My E11 Blaster Build.WIP

[TIE1138]

A few more pics of the details

[TIE1138]

Here are some pics of the T Track assembly. I used timber dowel to fill in some of the holes where the track starts and ends. I used Ullrich Aluminium Sliding Door Track section UA 1341 and it looks good.

[MattG]

Back to it eh? That's looking real sharp!

[TIE1138]

Thanks Matt. The Blaster is almost finished but have concentrated on other projects as well so this got put on the back burner so to speak.

[TIE1138]

I next made the Barrel Inner Tube from some aluminium tube and timber shaped on Blaxmyths lathe and turned to fit the Outer Sleeve.

[TIE1138]

The Barrel End and Receiver End.

[TIE1138]

Yes I even made a large spring for the Bolt and now I need to make a smaller diameter one for the inside. Looks good though. Cut the heads off a couple of cap screws and glued them to the Muzzle.

[TIE1138]

Here are a couple of more pics

[Blaxmyth]

Crikey, that's beautiful work! What's the size of the cylinders? They look more detailed than the originals!