My E11 Blaster Build.WIP
Posted: Wed Oct 11, 2017 8:23 am
Hi all. It's been a while and started this build 3rd Sept after a visit to Ootas place. Managed to get some seconds in the way of most components for this build and together with a pvc tube that already had the holes drilled in it, I decided to get on with it.
Motivation is the name of the game, and when I saw what Oota was doing, it spured me on.
So, the first thing to do was to mark out the position of the grip and tidy this up with a lot of sanding to even up the front and rear faces as these were out of alinment during the fabrication stage. after tidying this area, I stuck some sandpaper to the outer barrel tube and began to sand and shape the top face that will be secured to the tube. I drilled a large hole through the top of the tube so that I could screw the grip to the tube when ready. I then worked on the magazine housing and did similar work to this as the grip.
Motivation is the name of the game, and when I saw what Oota was doing, it spured me on.
So, the first thing to do was to mark out the position of the grip and tidy this up with a lot of sanding to even up the front and rear faces as these were out of alinment during the fabrication stage. after tidying this area, I stuck some sandpaper to the outer barrel tube and began to sand and shape the top face that will be secured to the tube. I drilled a large hole through the top of the tube so that I could screw the grip to the tube when ready. I then worked on the magazine housing and did similar work to this as the grip.